Stove Disassembly; Wiring Diagrams - Vermont Castings SDVR Series Homeowner's Installation & Operating Manual

Stove Disassembly

If there is ever a need to remove the firebox assem-
bly from the stove shell, support the firebox with solid
stands about 6" (152mm) tall under the left and right
outer edges of the firebox base. Do not set the firebox
assembly directly on the floor; this can damage the
control valve and/or the gas lines from the valve to the
firebox.
Before removing the firebox from the shell, disconnect
the on/off switch wires from the valve. If the assembly
includes the optional fan, disconnect the fan rheostat.
If the installation includes a wall thermostat, disconnect
the thermostat leads from valve.
Disconnection and reconnection to the gas line should
only be done by a qualified gas service technician.
Upon reinstallation, the vent system must be sealed to
the firebox as shown in the installation section, page
14. Also be sure the logs are placed in the firebox cor-
rectly, as shown in Page 25, Figures 43-44.

Wiring Diagrams

On/Off Switch
Wiring
TP/TH
TP
TH
Optional Thermostat
Wiring
TP/TH
TP
TH
Fig. 72 PDV20/SDVR on/off switch and optional thermostat
circuit.
NOTE: IF ANY OF THE ORIGINAL WIRE, AS SUP-
PLIED WITH THE APPLIANCE, MUST BE RE-
St124c
PLACED, IT MUST BE REPLACED WITH TYPE
SF-2, 200°C WIRE OR ITS EQUIVALENT.
Thermostat
wiring
1/11/00 djt
20007066
ON
OFF
Millivolt
Gas Valve
Black
Thermostat
(Optional) Thermostat
(Optional)
St124b
on/off/switch
wiring
1/11/00 djt
Black
Pinnacle & Stardance Direct Vent - Rear Vent Gas Heaters
Chassis
Ground
Chassis Ground
ST124b
MOTOR
ST124c
Fig. 73 PDV20/SDVR fan circuit.
POWER
CORD
WHT
GRN
BLK
FAN JUNCTION BOX
Strain Relief
ON / OFF
Rheostat
Snapstat
WHT
BLK
GRN
RHEOSTAT / SNAPSTAT
BOX
Schematic Diagram
ST153
rdv connections diag.
10/99
BLK
BLK
ON/OFF
RHEOSTAT
ST236
FK26 wiring diagram
12/99
FAN
BLK
ST153
SNAPSTAT
WHT
ST234
39