Maintenance; Annual System Inspection; Logset And Burner Cleaning; Care Of Cast Iron - Vermont Castings SDVR Series Homeowner's Installation & Operating Manual

Your PDV20 and SDVR Gas Heaters will provide years
of service with minimal upkeep. The following proce-
dures will help ensure that your stove continues to
function properly.

Annual System Inspection

Have the entire heater and venting system inspected
annually by a qualified gas technician. Replace any
worn or broken parts.
Logset and Burner
Cleaning and Inspection
Cleanliness is critical to the proper function of the
heater. The logset and burner must all be kept free of
dust and unobstructed by debris. Inspect these areas
before each use and clean as necessary.
1. Turn the burner OFF and let the heater cool com-
pletely before cleaning.
2. Lift the Stove Front up and then swing the bottom
out to disengage it from the heater shell. (Fig. 67)
3. Carefully remove the glass and frame assembly
and place it out of the way on a flat, padded surface
such as a counter protected by a towel.
4. Carefully inspect the Logs for damage. Contact
your local dealer if any damage is evident. DO NOT
OPERATE THE HEATER WITH DAMAGED LOGS.
5. Use a soft bristled brush to sweep dust or debris
from the Logs, Pilot and Burner. Use care as the
logs are fragile and susceptible to damage.
6. Replace the glass panel and frame assembly.
7. Replace the Stove Front.

Care of Cast Iron

An occasional dusting with a dry rag will help keep the
painted surfaces looking new. Use high-temperature
stove paints, available through your local dealer, to
touch-up areas as needed. Clean areas to be painted
with a wire brush and be sure to cover the logs, burner
and valve assembly, glass and frame assembly. Apply
the paint sparingly; two light coats of paint will give bet-
ter results than a single heavy coat.
Clean porcelain enamel surfaces with a soft, damp
cloth. Do not use abrasive cleaning agents. If neces-
sary, use only a cleaning agent formulated especially
for use on porcelain enamel surfaces.
20007066
Pinnacle & Stardance Direct Vent - Rear Vent Gas Heaters

Maintenance

TURN THE PILOT OFF BEFORE PAINTING.
ALLOW THE HEATER TO COOL COMPLETELY
BEFORE PAINTING.
WARNING: Let the glass cool completely before at-
tempting to clean.
It will be necessary to clean the glass periodically. Dur-
ing start-up, condensation, which is normal, forms on
the inside of the glass and causes lint, dust and other
airborne particles to cling to the glass surface. Also
initial paint curing may deposit a slight film on the glass.
It is therefore recommended that the glass be cleaned
two or three times with a non-ammonia household
cleaner and warm water (we recommend gas fireplace
glass cleaner). After that the glass should be cleaned
two or three times during each heating season depend-
ing on the circumstances present.
Replace glass only with CFM Corporation approved
parts. Refer to Page 40 for Replacement Parts. Refer to
Figure 68 and previous instructions for removal of the
damaged glass frame.
Fig. 67 Remove the Stove Front.
CAUTION

Cleaning the Glass

Clean glass after first two weeks of opera-
tion.

Glass Replacement

ST474c
Stardance
Rear vent
Remove Front
10/12/00
ST474d
37