Panel Description; Front Panel - Icom IC-7200 Instruction Manual

50 mhz
Hide thumbs Also See for IC-7200:
Table of Contents

Advertisement

1

PANEL DESCRIPTION

■ Front panel

Speaker
i7200
q PASSBAND TUNING CONTROLS [TWIN PBT]
Adjust the receiver's DSP filter passband width.
(p. 46)
• The limit of the variable range depends on the pass-
band width and mode. The limit of the variable range
is half of the passband width, and PBT is adjustable in
200 Hz (AM) or 50 Hz (other models) steps.
• Rotate both [TWIN PBT] controls (PBT1 and PBT2) to
the same position shifts the IF.
4 What is the PBT control?
Generally, the PBT electronically narrows the IF
passband width to reject interference. This trans-
ceiver uses the DSP circuit for the PBT function.
TWIN PBT
High cut
1
q
MODE
TUNER
PBT2
PBT1
TWIN PBT
TWIN PBT
Center
Low cut
Function
Display (p. 7)
TS
FILTER
SPCH
w NOISE BLANKER KEY
➥ Push to turn the noise blanker function ON or
OFF.
• "
" appears on the display.
➥ Push and hold for 1 sec to enter the noise
blanker set mode for setting the noise blanker
level and blank time; push again to return to nor-
mal operation.
• When entering the noise blanker set mode, the noise
blanker function is automatically turned ON.
4 What is the noise blanker?
The noise blanker reduces pulse-type noise such
as that generated by automobile ignition systems.
This function is not effective against non pulse-type
noise.
e NR KEY
NR
➥ Push to turn the noise reduction function ON or
OFF.
• "
" appears on the display.
➥ Push and hold for 1 sec. to enter the noise re-
duction level set mode; push again to return to
+
normal operation.
• When entering the noise reduction set mode, the
noise reduction function is automatically turned ON.
4 What is the Noise Reduction function?
The Noise Reduction (NR) function removes ran-
dom noise from the receiver passband. The level is
adjustable to allow maximum clarity without harm-
ing the intelligibility of the desired signal. Noise Re-
duction should generally not be used with digital
modes.
w
e
r
ANF
NB
NR
METER
V/M
1
A/B
2
SPLIT
1.8
=
3.5
4
5
MW
M-CL
AGC
10
14
7
8
COMP
SCAN
VOX
21
24
.
0
F-INP
RIT
MNF
GENE
50
P.AMP
ATT
M-CH/RIT
SET
o
i
u
(p. 49)
NB
(p. 50)
t
3
7
6
18
9
28
ENT
BAND
y

Advertisement

Table of Contents
loading

This manual is also suitable for:

I7200

Table of Contents