Close Call Hits - Uniden UBC800XLT Owner's Manual

UB356ZH.fm Page 96 Wednesday, December 19, 2007 11:28 AM
Infinite — The scanner stops and requires you to manually select another
operation to enable its return.
Set CC Bands — Lets you select the Close Call band settings. You can turn the
following bands on or off.
VHF Low 1 : On/Off: 25.0000 - 53.9875 MHz Plan1
: 25.0000 - 53.9950 MHz Plan2
: 25.0000 - 53.9937 MHz Plan3
VHF Low 2 : On/Off: 54.0000 - 107.9500 MHz
Air Band : On/Off : 108.0000 - 136.9875 MHz Air 12.5k
: 108.0000 - 136.9916 MHz Air 8.33k
VHF High 1 : On/Off : 137.0000 - 224.9950 MHz
VHF High 2 : On/Off : 225.0000 - 319.9750 MHz
UHF : On/Off : 320.0000 - 512.0000 MHz
800MHz+ : On/Off : 806.0000 - 1300.0000 MHz
Use the Scroll Control
to select On or Off and press
Call operation (works for all frequencies listed above).

Close Call Hits

When the scanner detects a Close Call hit, it alerts you according to the Override
and Alert settings in the previous section.
While listening to a Close Call hit, you can press [HOLD/RESUME] to hold on the
hit frequency, press [E
to lock out the frequency from Close Call and Search operation, or wait for the
transmission to end. If you are in Close Call Only or Close Call Override mode,
and you do not press any key, the scanner returns to its previous operation after
the transmission ends and the set delay time expires.
If you are holding on the frequency, press [HOLD/RESUME] again to resume the
previous operation.
Close Call Hits are just the last 10 hits received in Close Call mode. The hits go
away when you cycle power (if you want to store it "permanently" press [E
when the scanner is on the frequency; the scanner then stores the frequency into
the "Close Call" system which does show up in the systems list).
96
to select a band, press
F
. Turning off undesired bands speeds up Close
] to quickly save the frequency into memory, press [L/O]
YES
F
, then use the Scroll Control
]
YES