Uniden UBC800XLT Owner's Manual page 30

UB356ZH.fm Page 30 Wednesday, December 19, 2007 11:28 AM
UBC800XLT
Desk Surface
Wood Screws
Bracket
To secure the radio, by means of the mounting bracket, to a surface, follow the
steps below:
1. Attach the four protective rubber feet to the mounting bracket when you
casually use the scanner on a flat surface. Should you desire to permanently
mount the scanner, remove the feet and use wood screws through the bracket
as described in Steps 2 and 3.
2. Use the bracket as a template to mark positions for the two mounting screws.
3. At the marked positions, drill holes slightly smaller than the screws.
4. Align the bracket with the threaded holes on the sides of the radio case so the
bracket is beneath the radio. Secure the bracket using the two threaded
knobs. Never overtighten the knobs.
Once the radio is positioned, connect it to a source of AC power using the supplied
13.8V, 750 mA AC adapter. Insert the barrel of the AC adapter to the jack on the
rear, upper right side of the radio marked
WARNING!
Use only the Uniden-supplied AC adapter with this scanner.
30
Mounting Feet (4)
Apply beneath
the bracket;
between bracket
and desk surface.
.