Uniden UBC800XLT Owner's Manual page 68

UB356ZH.fm Page 68 Wednesday, December 19, 2007 11:28 AM
Note: Motorola analog systems use talk group ID's in multiples of 16. ID numbers
that fall between these ID's indicate special status flags for the system. This setting
determines how the scanner will handle ID's that are not multiples of 16.
Select your setting then press
Setting End Code Operation
[MENU]
Program System
Select a Motorola Type I or II system
Edit Sys Option
Set End Code
This setting determines how the scanner handles the transmission end code sent
by most Motorola systems. Select your setting then press
Yes — the scanner immediately returns to the control channel when it detects the
end code.
Ignore — the scanner does not return to the control channel until the carrier
drops.
Note: The default setting is Yes.
Setting I-Call Operation
[MENU]
Program System
Select a Motorola Type I, II or EDACS Wide/Narrow system
Edit Sys Option
F
Set I-Call
This setting determines how your scanner treats I-calls while ID Searching.
On — the scanner tracks I-calls.
Off — the scanner ignores I-calls. The default setting is Off.
Only — the scanner only tracks I-calls and ignores other radio traffic on the
F
system. Press to select.
Note: To set the I-Call to a wildcard receive condition, press [.No] + [0].
Setting the Emergency Alert Option
[MENU]
Program System
Select a Motorola Type I, II or EDACS Wide/Narrow system
68
F
.
F
F
F
F
F
F
F
F
.
ME
F
ME
F
M