Resetting The Microprocessor; On/Standby - Denon AVR-2112CI Owner's Manual

Symptom
Cannot login to Login information is incorrect. Check if the "Email address" for
Pandora. ("Email Pandora has been properly entered. Re-enter the "Password".
address" or (Password is not displayed.)
"Password" is http://www.pandora.com/denon
displayed.)
GAirPlayH
Symptom
The AirPlay icon This unit and the computer or iPhone/iPod touch/iPad are not
is not displayed connected to the same network (LAN). Connect the computer or
in iTunes or on the iPhone/iPod touch/iPad to the same network as this unit.
iPhone/iPod touch/ iTunes or the iPhone/iPod touch/iPad do not have firmware that
iPad. supports AirPlay installed. Update to the latest firmware.
No sound. The volume in iTunes or on the iPhone/iPod touch/iPad is set to
the minimum setting. Adjust the volume to the optimum level.
This unit is not selected in the screen that is displayed when
iTunes or the iPhone/iPod touch/iPad is started. Start iTunes or
switch on the iPhone/iPod touch/iPad, click the AirPlay icon
the displayed screen, and select this unit.
GRemote Control UnitH
Symptom
The set cannot be Batteries are worn out. Replace with new batteries.
operated with the Operate the remote control unit within a distance of about
remote control unit. 23 ft/7 m from this unit and at an angle of within 30°.
Remove any obstacle between this unit and the remote control
unit.
Insert the batteries in the proper direction, checking the q and
w marks.
The set's remote control sensor is exposed to strong light (direct
sunlight, inverter type fluorescent bulb light, etc.). Move the set
to a place in which the remote control sensor will not be exposed
to strong light.
The ZONE SELECT setting is not correct. Press
select the zone to operate.
The operation mode does not match the settings of the device to
operate. Check the operation mode.
Cause/Solution
Cause/Solution
in
Cause/Solution
ZONE SELECT
to

Resetting the microprocessor

Page
39
Perform this procedure if the display is abnormal or if operations cannot be performed.
When the microprocessor is reset, all the settings are reset to their default values.

ON/STANDBY

Page
12
96
–
64
1
Turn off the power using
2
ON/STANDBY
Press while simultaneously pressing
Page
PRESET CHANNEL 3
.
116
3
116
2QFH WKH GLVSOD\ VWDUWV ÀDVKLQJ DW LQWHUYDOV RI DERXW  VHFRQG UHOHDVH WKH WZR
buttons.
116
116
If in step 3 the display does not flash at intervals of about 1 second, start over from step 1.
116
105
105
129
PRESET CHANNEL 2
PRESET CHANNEL 3
ON/STANDBY
.
PRESET CHANNEL 2
and