Denon AVR-2112CI Owner's Manual page 98

Option Setup
Make various other settings.
Setting items
Volume Control Volume Display : Set how volume is displayed.
Set the MAIN ZONE (room Relative : Display ---dB (Min), in the range –80.5 dB to 18 dB.
where the unit is located) Absolute : Display in the range 0 (Min) to 99.
volume setting.
The "Volume Display" setting is applied also to the "Volume Limit" and
"Power On Level" display method.
The "Volume Display" setting applies to all zones.
Volume Limit : Make a setting for maximum volume.
OFF : Do not set a maximum volume.
–20dB (61) / –10dB (71) / 0dB (81)
Power On Level : Define the volume setting that is active when the
power is turned on.
Last : Use the memorized setting from the last session.
– – – (0) : Always use the muting on condition when power is turned on.
–80dB – 18dB (1 – 99) : The volume is adjusted to the set level.
Mute Level : Set the amount of attenuation when muting is on.
Full : The sound is muted entirely.
–40dB : The sound is attenuated by 40 dB down.
–20dB : The sound is attenuated by 20 dB down.
Source Delete BD / DVD / TV / SAT/CBL / GAME1 / GAME2 / V.AUX / DOCK /
Remove from the display NET/USB / TUNER / CD : Select input source that is not used.
input sources that are not ON : Use this source.
used. Delete : Do not use this source.
NOTE
Input sources being used in the various zones
cannot be deleted.
Input sources set to "Delete" cannot be
selected using the input source select button.
Default settings are underlined.
Setting details
Setting items
GUI Screensaver : Make screensaver settings.
Make the settings related to ON : The screensaver is activated during menu
displays on the TV screen. display, NET/USB, iPod or TUNER screen
display if no operation is performed for an
approximately 5-minute continuous period.
When you press
cancelled and the screen before that screen
saver started is displayed.
OFF : Screensaver is not activated.
Format : Set the video signal format to be output for the TV you are using.
NTSC : Select NTSC output.
PAL : Select PAL output.
"Format" can also be set by the following procedure. However, the menu
screen is not displayed.
1. Press and hold the main unit's
seconds.
"V.Format:<NTSC>" appears on the display.
2. Press the main unit's
format.
3. Press the main unit's
NOTE
When a format other than the video format of the connected TV is set, the
picture will not be displayed properly.
Text : Display the details of operation when switching surround mode,
input mode, etc.
ON : Turn display on.
OFF : Turn display off.
Master Volume : Display the master volume during adjustment.
Bottom : Display at the bottom.
Top : Display at the top.
OFF : Turn display off.
When the master volume display is hard to see when superimposed
on movie subtitles, set to "Top".
95
System Setup
Setting details
uio p
, the screensaver is
PRESET 1 PRESET 3
and for at least 3
TUNER PRESET CH +, –
and set the video signal
V to complete the setting.
INTERNET RADIO
vSee overleaf