Other Functions; Auto Standby; Last Function Memory; Resetting The Microprocessor - Denon RCD-M39 Owner's Manual

Other functions

Using an optimizing filter
An optimizing filter suited for the properties of the speakers (SC-M39)
can be used.
1
Press SETUP .
2
ui
Use to select "SPK
OPTIMISE", then press the
ENTER p
or .
3
ui
Use to select "ON", then press the
The setting is entered.
ON The response is optimized for the speakers (SC-M39, sold
separately).
The response is flat.
OFF
Auto power on
When the power is in standby, the power
turns on when any of the buttons below
POWER X
other than is operated, and the
respective operation is performed.
5
• (on the main unit) ......... The disc tray opens.
1 3
• / ................................. Playback of the "CD", "iPod" or "USB"
starts.
CD
• .................................... The source switches to "DISC".
TUNER
• .............................. The source switches to "TUNER" and the
band last set is tuned in.
iPod/USB
• ......................... The source switches to "iPod/USB".
DIGITAL IN
• ....................... The source switches to "DIGITAL IN".
ANALOG IN
• ...................... The source switches to "ANALOG IN".
DISC

Auto standby

With the Auto standby ON, this unit will automatically enter the
standby mode after about 30 continuous minutes of stop mode with
no operation.
For the input source "ANALOG IN" only, when no operation is
performed for eight hours, this unit automatically enters the standby
mode.
1
Press SETUP .
2
ui
Use to select "AUTO
ENTER p
or .
STANDBY", then press
p
or .
3
Use ui to select "ON", then press
The setting is entered.
NOTE
In the following situations, the Auto standby function does not operate.
• When an iPod (Remote mode) is connected to the USB port on the
unit.
• When the source is "TUNER".
• The default setting for the Auto Standby mode is "ON".

Last function memory

This stores the settings as they were immediately before going into
the standby mode.
When the power is turned back on, the settings are restored to as
they were immediately before going into the standby mode.

Resetting the microprocessor

Perform this procedure if the display is abnormal or if operations
cannot be performed.
When the microprocessor is reset, all the settings are reset to their
default values.
ENTER
ENTER or p .
1
2
If "INITIALIZE" does not display in step 2, start over from step 1.
27
SOURCE
Unplug the power cord.
Plug the power cord into a power outlet while
8/– SOURCE
simultaneously pressing and
main unit.
"INITIALIZE" is displayed.
8/–
on the