Denon AVR-2112CI Owner's Manual page 84

Tone
Adjust the tonal quality of the sound.
Setting items
Tone Control ON : Allow tone adjustment (bass, treble).
Set the tone control function OFF : Playback without tone adjustment.
to ON and OFF.
"Tone Control" can be set when "Dynamic EQ ® "
set to "OFF".
NOTE
"Tone Control" settings are not reflected to ZONE2.
The tone cannot be adjusted in the "DIRECT" mode.
Bass –6dB – +6dB
Adjust low frequency range
"Bass" can be set when "Tone Control" is set to "ON".
(bass).
Treble –6dB – +6dB
Adjust high frequency range
"Treble" can be set when "Tone Control" is set to "ON".
(treble).
Setting details
(vpage 82) is
Audyssey Settings
Set Audyssey MultEQ ® XT, Audyssey Dynamic EQ ® and Audyssey Dynamic Volume ® . These can be
selected after Audyssey ® Auto Setup has been performed. For additional information on Audyssey
technology, please see page 123.
NOTE
If you have not performed Auto Setup, or if you change the speaker settings after performing Auto Setup,
you may not be able to select Dynamic EQ ® /Dynamic Volume ® .
In this case, either perform Audyssey ® Auto Setup over again or perform "Restore" (vpage 20) to
return to the settings after Audyssey ® Auto Setup was run.
When HD Audio for which the sampling frequency exceeds 96 kHz is played back, the "Audyssey
Settings" cannot be set.
Setting items
MultEQ ® XT
Audyssey : Optimize the frequency response of all speakers.
MultEQ ® XT corrects
Audyssey Byp.L/R : Optimize frequency response of speakers except
both time and frequency front L and R speakers.
response problems in the Audyssey Flat : Optimize frequency response of all speakers to flat
listening area based on response.
Audyssey ® Auto Setup
Manual : Apply frequency response set with "Manual EQ" (vpage 83).
OFF : Turn "MultEQ ® XT" equalizer off.
calibration. We recommend
"Audyssey".
MultEQ ® XT is the
"Audyssey", "Audyssey Byp. L/R" and "Audyssey Flat" can be selected
prerequisite function for
after Audyssey ® Auto Setup has been performed. "Audyssey" is
Dynamic EQ ® and
automatically selected after performing Audyssey ® Auto Setup. When
Dynamic Volume ® .
"Audyssey", "Audyssey Byp. L/R" or "Audyssey Flat" is selected,
illuminates.
After running Audyssey ® Auto Setup, if the Speaker Configuration,
Distance, Channel Level, and Crossover Frequency have changed
without increasing the number of speakers measured, only
illuminates.
NOTE
"MultEQ ® XT" and "Manual" cannot be selected when "EQ Customize"
is set to "Not Used" (vpage 90).
When using headphones, "MultEQ ® XT" is automatically set to "OFF".
"MultEQ ® XT", "Dynamic EQ ® " and "Dynamic Volume ® " settings are stored for each input source.
81
Audio Adjust
Default settings are underlined.
Setting details
vSee overleaf