Microsoft Network (Smb); Preparations; Configuration Procedure - Xerox 4112 System Administration Manual

Configuration
Note
Refer to the manual contained in the "CentreWare Utilities" CD-ROM for the configuration
procedure.

Microsoft Network (SMB)

Preparations

The following items are required when using a Microsoft Network (SMB):
• Network environment where either TCP/IP or NetBEUI can be used.
• The "CentreWare Utilities" CD-ROM, which is included with this product.

Configuration procedure

Overview
The machine can be connected to computers using Microsoft Networks (SMB).
Depending on the network environment, the machine may need to be configured with an IP
address, subnet mask and gateway address. Confirm with the network administrator and set up
the necessary items.
The following is the procedure to connect the machine to a Microsoft Network (SMB):
• Configuration on the Machine: Enable the SMB port on the machine.
• Configuration on the Computer: Install the print driver.
Configuration on the machine (SMB)
This section describes the configuration procedure to connect the machine to Microsoft
Networks (SMB). First enable the SMB port, then set the IP address.
Notes
• The configuration can also be performed using the IP configuration tools included in
CentreWare Internet Services or CentreWare Utilities. Refer to "Using CentreWare Internet
Services".
• Enable the SOAP port and the SNMP port in most cases.
1. Enter the System Administrator Mode (Chapter 1 Entering the System Administrator mode
on page 1-10.)
2. Enable the SMB port.
a. Select System Settings.
b. Select Connectivity & Network Setup.
c. Select Port Settings.
d. Select SMB and then select Change Settings.
e. Select Port Status and select Change Settings.
2-4 System Administration Guide
Xerox 4112/4127 Copier/Printer