Connection To Peripheral Equipment; Connection To The Ad-8121B Printer; Connection To A Computer - A&D GX-300 Instruction Manual

17. CONNECTION TO PERIPHERAL EQUIPMENT

17-1 Connection to the AD-8121B Printer

Set the following parameters to use the AD-8121B printer.
Function setting
dout prt 0-3
dout ap-p 0-2
dout ap-b 0-2
dout pU5e 0, 1
5if bp5 2
5if btpr 0
5if Crlf 0
5if Ct5 0
When "MODE 1" or "MODE 2" of the AD-8121B printer is used
dout 5-td 0
dout 5-id 0
dout at-f 0
5if type 0
When "MODE 3" of the AD-8121B printer is used.
dout 5-td 0-3
dout 5-id 0, 1
dout at-f 0, 1
5if type 1
When data is transmitted continuously.
When all memory data is transmitted at one time.
dout pU5e 1
Note
The printer performs as follows, depending on the data memory setting.
Setting
data 0
data 2
data 3
Refer to "11. ID NUMBER AND GLP REPORT" for a print sample.

17-2 Connection to a Computer

The GX series balance is of the DCE type (Data Communication Equipment), which can be
connected to a personal computer using the RS-232C interface.
Before connection, read the personal computer manual thoroughly.
Use a standard DCE cable for connection (cable type: straight-through).
Description
Selects a print mode.
Selects the polarity for the auto print mode.
Selects the auto print difference.
Selects data output pause.
Factory setting 2400 bps
Factory setting 7 bits, Even parity check
Factory setting CR, LF
Factory setting CTS and RTS control, not used
Factory setting Not to output the time and date.
Factory setting Not to output the ID number.
Factory setting Not to use auto feed.
Factory setting A&D standard format
Outputs the time and date as necessary.
Outputs the ID number as necessary.
Uses auto feed as necessary.
DP format
Uses pause.
What is printed
The weighing data
The weighing data stored in memory
The calibration or calibration test data stored in memory
67