Setting The Powered Zone 2 - Integra DTR-6.9 Instruction Manual

Zone 2—Continued

Setting the Powered Zone 2

If you've connected your Zone 2 speakers to the AV
receiver, as explained in "Connecting Your Zone 2
Speakers Directly to the AV receiver" on page 113, you
must set the "Powered Zone2" setting to "Act" (Acti-
vated).
1
Press the [Receiver] button fol-
lowed by the [Setup] button.
Remote
The main menu appears onscreen.
controller
If the main menu doesn't appear, make
sure the appropriate external input is
selected on your TV.
2 Use the Up and Down [ ]/[ ] but-
tons to select "7. Hardware
Setup", and then press [Enter].
The "Hardware Setup" menu appears.
7. Hardware Setup
1. Remote Control
2. Zone2
3. Tuner
4. Analog Multich
5. HDMI
6. Network
3
Use the Up and Down [ ]/[ ] but-
tons to select "2. Zone2", and
then press [Enter].
The "Zone2" menu appears.
7–2. Zone2
Powered Zone2
Zone2 Out
4
5
Notes:
• When "Act" is selected and Zone 2 turned on, the
Zone 2 speakers connected to the Zone 2 L/R speaker
terminals output sound, but the surround back speak-
ers connected to the SURR BACK L/R speaker termi-
nals do not. When "Act" is selected and Zone 2 turned
off, the surround back speakers output sound as nor-
mal.
• Powered Zone2 cannot be used if "Speakers Type" is
set to "Bi-Amp" (see page 44).
• This procedure can also be performed on the AV
receiver by using its [Setup] button, arrow buttons, and
[Enter] button.
Not Act
Fixed
Use the Up and Down [ ]/[ ] but-
tons to select "Powered Zone2",
and use the Left and Right [ ]/
[ ] buttons to select:
Not Act:
Zone 2 L/R speaker terminals not
activated (Powered Zone 2 dis-
abled).
Act:
Zone 2 L/R speaker terminals acti-
vated (Powered Zone 2 enabled).
Press the [Setup] button.
The setup menu closes.
115