Using The 12V Triggers - Integra DTR-50.2 Instruction Manual

Using the 12V Triggers

The 12V triggers A, B, and C can be used to turn on 12V
trigger-capable components automatically when they are
selected as the input source. The triggers can be set so that
they activate when a connected component is selected as
the input source for the main room, Zone 2, Zone 3 or any
combination of rooms. When triggered, the output from a
12V TRIGGER OUT goes high (+12 volts and 150 milli-
amperes max. at TRIGGER OUT A; +12 volts and 25 mil-
liamperes max. at TRIGGER OUT B and C).
Hookup
• Use a miniplug cable to connect the AV receiver's 12V TRIG-
GER OUT A, B, or C jack to the 12 V trigger input on a con-
nected component.
When several components are turned on simultaneously
by using triggers A, B, and C, depending on the type of
components, a large amount of current may be drawn
momentarily. To prevent this, you can delay trigger signals
A, B, and C individually. Another application for trigger
delay is eliminating the "thump" noise that's sometimes
heard when a source component is turned on. Delaying the
trigger signal for your power amplifier so that it's the last
component to be turned on will accomplish this.
1
Press Receiver followed by Setup.
The main menu appears on screen.
2
Use / to select "Miscellaneous", and then press
Enter.
The "Miscellaneous" menu appears.
3
Use / to select "12V Trigger A, B or C Setup",
and then press Enter.
The "12V Trigger A, B or C Setup" screen appears.
6-3. 12V Trigger A Setup
Delay
BD/DVD
VCR/DVR
CBL/SAT
GAME
PC
AUX
En
82
4
5
6
0sec
Main
Main
Main
Main
Main
Main
Use / to select "Delay", and use
0sec (Trigger A: default),
1sec (Trigger B: default),
2sec (Trigger C: default),
or 3sec.
When 0 sec is selected, the trigger signal is output as
soon as the input source is changed.
Use / to select an input source, and use
select an option.
Off:
No trigger signal is output. A 12-volt trigger
signal is output when the connected component
is selected as the source for:
Main (Trigger A: default):
Main room.
Zone 2 (Trigger C: default):
Zone 2.
Main/Zone 2:
Main room or Zone 2.
Zone 3:
Zone 3.
Main/Zone 3:
Main room or Zone 3.
Zone 2/Zone 3:
Zone 2 or Zone 3.
Main/Zone 2/Zone 3:
Main room, Zone 2, or Zone 3.
When you've finished, press Setup.
The setup menu closes.
/ to select:
/ to