Learning Commands - Integra DTR-50.2 Instruction Manual

6
Press Enter.
A message for transfer will appear.
8–2. Activities Setup
Now we are ready to transfer data to the remote.
Please hold the remote so that it is facing the receiver.
Use ENTER button of your remote to activate "OK".
Ready?
OK
To use the remote controller, point it at the AV
receiver's remote control sensor, as shown below.
Transmitter
Incoming sensor
15
15° off center
(Left/Right/Up/Down)
7
Press Enter.
8–2. Activities Setup
When the transfer is successful, the following screen
appears.
8–2. Activities Setup
Return
8
Press Enter.
The "Activities Setup" menu appears onscreen.
9
Press Setup.
The setup menu closes.
My Movie
AV receiver
15
Approx.
16ft. (5 m)
My Movie
Wait...
My Movie
Successful

Learning Commands

The AV receiver's remote controller can learn the com-
mands of other remote controllers. By transmitting, for
example, the Play command from your CD player's
remote controller, the remote controller can learn it, and
then transmit the exact same command when its
pressed in the CD remote mode.
This is useful when you've entered the appropriate remote
control code (➔ 91) but some buttons don't work as
expected.
On
Remote
Mode
1
While holding down Remote Mode for the mode
in which you want to use the command, press and
hold down On until Remote Mode button lights
(about 3 seconds).
2
On the supplied remote controller, press the but-
ton you want to learn the new command.
3
Point the remote controllers at each other, about 2
to 6 inches (5 to 15 cm) apart, and then press and
hold the button whose command you want to learn
until Remote Mode button flashes.
If the command is learned successfully, Remote
Mode button flashes twice.
About 2 to 6 inches
(5 to 15 cm)
Supplied remote
controller
4
To learn more commands, repeat steps 2 and 3.
Press any Remote Mode when you've finished.
Remote Mode button flashes twice.
is
En
95