Using Bypass Tray - Toshiba e-studio182 Operator's Manual

Using Bypass Tray

Place paper on the bypass tray when you use the following media types as copy paper:
Thick paper (21 lb. Bond to 90 lb. Index)
Special media types such as tracing paper, sticker labels or overhead transparencies
Standard size paper which cannot be placed in the drawers of the equipment and Paper
Feed Unit (optional) (e.g. ST-R)
Using the bypass tray is recommended also for copying on standard-size paper other than those
placed in the drawers. The following sizes are available for bypass copying:
Media type
Plain paper
(17 - 20 lb. Bond)
THICK PAPER 1
(21 - 28 lb. Bond)
THICK PAPER 2
(29 lb. Bond - 90 lb.
*3
Index)
Tracing paper
*3
(20 lb.)
Sticker labels
Transparencies
*1 "Maximum sheet capacity" refers to the maximum number of sheets when TOSHIBA-recommended
paper is used. See the following page for the TOSHIBA-recommended paper:
P.38 "Recommended paper"
*2 The paper of 13 to 16 lb. Bond can be used if it is set on the bypass tray one by one.
*3 Automatic duplex copying is not available.
*4 Be sure to use the overhead transparencies that TOSHIBA recommends. When transparencies other
than the TOSHIBA-recommended ones are used, this could cause an equipment malfunction.
LT format:
LD, LG, LT, LT-R, ST-R, COMP, 13"LG
*2
A/B format:
A3, A4, A4-R, A5-R, B4, B5, B5-R, FOLIO
*3
*3
*3, *4
LT only
Paper size
Maximum sheet
*1
capacity
100 sheets (17 lb. Bond)
100 sheets (20 lb. Bond)
1 sheet
(21 - 28 lb. Bond)
1 sheet
(29 lb. Bond - 90 lb. Index)
1 sheet
1 sheet
1 sheet

Using Bypass Tray

61