Setting Up A Non-Bootable Raid Array - Foxconn Cinema II Deluxe User Manual

5-5 Setting Up a Non-Bootable RAID Array

This section assumes the following setup :
■ Boot Disk with Windows XP installed :
One hard disk HDS728090PLAT20 (80GB) is connected to the IDE channel, and set
to Master.
■ A Mirrored RAID Array Disk :
Two SATA hard disks are configured as a mirrored RAID1 array, they are :
Hitachi HDT725025VLA3, (250.05GB) connected to SATA port2 of the motherboard.
Seagate ST3320620AS, (320.07GB) connected to SATA port3.
■ A SATA DVD Drive :
A DVD drive connected to SATA port1.
To achieve the best performance and reliability, we highly recommend you
using the hard disks with the same brand, size and model number. Though
we are using different brand of hard disks as an example here, the purpose
is only for easy understanding.
1. Reboot your system, and go to "SATA Configuration" menu.
Enable the RAID function. Press [F10] to save the settings and reboot.
CMOS Setup Utility - Copyright (C) 1985-2009, American Megatrends, Inc.
SB710 SATA Controller
SB710 SATA Mode
↑↓←→:Move Enter:Select
SATA Configuration
[Enabled]
[RAID]
[RAID]
+/-/:Value F10:Save
F2/F3:Change Colors
99
Help Item
Options
Native IDE
RAID
AHCI
Legacy IDE
ESC:Exit F1:General Help
F9:Optimized Defaults