Hardware Monitor - Foxconn Cinema II Deluxe User Manual

Hardware Monitor

CMOS Setup Utility - Copyright (C) 1985-2009, American Megatrends, Inc.
Case Intrustion Alert
Hardware Monitor
CPU Temperature
System Temperature
North Bridge Temperature
CPU Fan Speed
System Fan Speed
CPU VCore Voltage
DRAM Voltage
+3.30V
+12.0V
HT/VTT/SB Voltage
VBAT
Smart Power LED
CPU Smart Fan Control
Fan off Temperature (
Fan on Temperature (
Fan on Startup speed (%)
Fan slope (%)
↑↓←→:Move Enter:Select
► Case Intrustion Alert
This item is used to enable or disable a warning message once the case intrusion alert has
been triggered.
► Hardware Monitor
This item is used to enable or disable Hardware Health Monitoring Device.
► CPU/System/NB Temperature
The CPU/System/NB temperature are automatically detected and displayed by the system.
► CPU Fan/System Fan Speed
The CPU fan/System fan speed are automatically detected and displayed by the system.
► CPU VCore/DRAM Voltage/+ 3.3V/+12.0V/NT/VTT/SB Voltage/VBAT
The current voltages are automatically detected and displayed by the system.
► Smart Power LED
Smart Power LED is a feature built on your motherboard to indicate different states during
Power On Self Test (POST). The LED is located at the front panel, and it displays POST state
by different long-short blinking intervals. You can always leave this state enabled.
System Status
Normal
No Memory
No Display
Post Error Message
No CPU Fan
► CPU Smart Fan Control / System Smart Fan Control
[Full On Mode]; [Automatic Mode].
This option is used to enable or disable smart fan function.
Hardware Monitor
[Disabled]
[Enabled]
:45 C/113
o
:40 C/104
o
:45 C/113
o
:2136 RPM
:N/A
:1.200V
:1.616V
:3.360V
:12.224V
:1.296V
:3.104V
[Disabled]
[Automatic mode]
C) [000]
o
C) [035]
o
[064]
[2]
+/-/:Value F10:Save
F2/F3:Change Colors
Power LED Status
Always On
Continue blinking On (1sec.), Off (1sec.)
Continue blinking On (2sec.), Off (2sec.)
Continue blinking On (1/2sec.), Off (1/2sec.)
Continue blinking On (1/2sec.), Off (1/2sec.)
35
Help Item
F Enables a warning
o
F message once the case
o
F intrusion alert has
o
been triggered
ESC:Exit F1:General Help
F9:Optimized Defaults
Stop Blinking Condition
Always On
Reboot & Memory OK
Reboot & Display OK
Enter Setup or Skip
Reboot & Fan OK