Integrated Peripherals - Foxconn Cinema II Deluxe User Manual

Integrated Peripherals

CMOS Setup Utility - Copyright (C) 1985-2009, American Megatrends, Inc.
► SATA Configuration
► USB Configuration
LAN Controller
LAN Boot ROM
1394 FireWire
USB Controller
Azalia HD Audio Controller
Serial Port Address
Ir Port Address
Ir Port Mode
Ir Port Duplex Mode
↑↓←→:Move Enter:Select
► SATA Configuration / USB Configuration
Press <Enter> to go to relative submenu.
► LAN Controller
This item is used to enable or disable the LAN controller.
► LAN Boot ROM
This item is used to enable or disable the LAN boot optional ROM. A LAN boot ROM
lets you set up a diskless workstation on the network. By installing a boot ROM in the network
board, you can enable a client PC system on the network to be booted remotely.
► 1394 FireWire
This item is used to enable or disable the onboard 1394 controller.
► USB Controller
This item is used to enable or disable the USB controller.
► Azalia HD Audio Controller
This item is used to enable or disable the Azalia HD Audio Controller.
► Serial Port Address
This item is used to assign the I/O address and interrupt request (IRQ) for the onboard serial
port 1.
► IR Port Address
This item is used to assign the I/O address and interrupt request (IRQ) for the IR port.
► IR Port Mode
This item is used to set the IR mode. The available settings are :
[IrDA] : An IrDA device for maximum 115200 bit/s.
[ASK IR] : A faster IrDA for 1152000 bit/s.
► IR Port Duplex Mode
This item enables you to determine the infrared function of the onboard infrared chip.
Integrated Peripherals
[Press Enter] [Press Enter]
[Press Enter]
[Enabled]
[Disabled]
[Enabled]
[Enabled]
[Enabled]
[3F8/IRQ4]
[2F8/IRQ3]
[IrDA]
[Half Duplex]
+/-/:Value F10:Save
F2/F3:Change Colors
30
Help Item
Configure the SATA
device(s).
ESC:Exit F1:General Help
F9:Optimized Defaults