Replace Jammed Originals If Restarting Job - Lexmark CX410e User Manual

Troubleshooting
Note: If you do not have a replacement imaging kit, then see the "Ordering supplies" section of the User's Guide or
visit www.lexmark.com.

Replace jammed originals if restarting job.

From the printer control panel, try one or more of the following:
• Select Scan from automatic feeder, and then press
last successful scan job.
•
Select Scan from flatbed, and then press
last successful scan job.
•
Select Finish job without further scanning, and then press
Note: This does not cancel the scan job. All successfully scanned pages will be processed further for copying or
e-mailing.
•
Select Restart Job, and then press
• Select Cancel Job, and then press
Replace maintenance kit, 0 estimated pages remain [80.xy]
The printer is scheduled for maintenance. For more information, visit the Lexmark support Web site at
http://support.lexmark.com
Replace missing [color] cartridge [31.xy]
Install the indicated toner cartridge to clear the message. For more information, see the "Replacing supplies" section
of the User's Guide.
Replace missing [type] imaging kit [31.xy]
Note: The type can be a black imaging kit, or a black and color imaging kit.
Install the indicated imaging kit to clear the message. For more information, see the "Replacing supplies" section of
the User's Guide.
Replace missing waste toner bottle [82.xy]
Install the missing waste toner bottle to clear the message. For more information, see the instruction sheet that came
with the supply.
Replace unsupported [color] cartridge [32.xy]
Remove the toner cartridge, and then install a supported one to clear the message.
Note: If you do not have a replacement cartridge, then see the "Ordering supplies" section of the User's Guide or
visit www.lexmark.com.
to continue scanning from the scanner glass immediately after the
to restart the scan job with the same settings from the previous scan job.
to clear the message and cancel the scan job.
or contact your service representative, and then report the message.
to continue scanning from the ADF immediately after the
to end the last successful scan job.
268