Switching Between Alarm And Event Buffers Indication; Display Indications - Bosch NurseCall Main Unit User Manual

44 en | Operation
5.2.1

Switching between alarm and event buffers indication

The alarm buffer is indicated by default. If you are in the event buffer, the unit changes
automatically to the alarm buffer after 1 minute without activity.
If there are no entries in the alarm buffer, the display shows the actual date and time.


5.2.2

Display indications

With the Yellow button, you can switch between three available information blocks.
The following information is displayed when an alarm or a message arrives:
First information block
–
1.
2.
3.
–
1.
2.
3.
Second information block
4.
5.
6.
7.
This information is visible in all display modes.
F.01U.252.699 | V1.1 | 2012.01
To switch from alarm to event buffer and vice versa, press
Scroll the alarms or the events with
In case of a "floor/room/bed" display mode:
criterion of the alarm or message
alarm (A) or event (E) followed by its order in the buffer
identification of the transmitter location (floor/room/bed numbers)
In case of "single number" display mode:
criterion of the alarm or message
alarm (A) or event (E) followed by its order in the buffer
identification of the transmitter location (three digits or four signs)
date of the event;
time of the event;
main unit (space) or relay Unit (A...f) identification number;
quality of the received radio signal.
and .
User Manual
NurseCall Main Unit
.
Bosch Security Systems