Programming With The Nps Software; Exit The Programming Mode And Cancel Entries; Key Not Allowed; Locking And Unlocking The Keyboard - Bosch NurseCall Main Unit User Manual

22 en | Programming
4.1.2

Programming with the NPS software

The NurseCall system can be programmed with a specific software called NPS.
NOTICE!
In order to program the NurseCall Main Unit with this software, you should connect your PC to
the NurseCall Main Unit with an RS-232 cable.

Enable the programming
1.
¬ NPS Programming
2.
¬
4.1.3

Exit the programming mode and cancel entries


4.1.4

Key not allowed


4.1.5

Locking and unlocking the keyboard


This function locks only the keyboard to prevent any false manipulation. The colored buttons
on the left hand side are still available.
When the keyboard is locked, a small lock appears at the bottom right of the display:
DATE:
TIME:
4.1.6

Programming time-out


4.2

First use

At first use or when resetting all the parameters, you must program:



See Section 4.4.2 Resetting all the parameters, page 34.
F.01U.252.699 | V1.1 | 2012.01
To connect and set the interface, see Section 3.2.6 Connecting the RS-232, page 17.
Press then
READY ?...
Confirm the command with
Programming NCall
.............
Press once or several times.
If you have pressed a key by mistake during the programming, a high-pitched beep is
generated.
Press then within one second to lock or unlock the keyboard.
03.01.12
12:12:31
Programming of the NurseCall Main Unit terminates automatically if no entries are made
on the keyboard for more than one minute.
the unit language
the locating mode
the display mode for the transmitters' identification
.
.
¨
½
User Manual
NurseCall Main Unit
Bosch Security Systems