Transmitters; Starting Programming; Programming An Alarm Transmitter - Bosch NurseCall Main Unit User Manual

38 en | Programming
4.5

Transmitters

4.5.1

Starting programming


4.5.2

Programming an alarm transmitter

1.
¯ Transmit. type : 0
Alarm Transmitter
2.
3.
¯´ Press Radio
4.
¯ Transmitter code
XXXX is the ID code of the transmitter.

5.

¯ Number
Value: ····
Enter a value for each sign. Press once to enter the digit of the key that you are pressing.
Press several times to enter a capital letter of the corresponding key. Example: to enter Z,
press 4 times on the key
6.
¯ Pager
Value: ·0
7.
¯ Transmitter
F.01U.252.699 | V1.1 | 2012.01
To access the programming of transmitters , press
Select the alarm transmitter type with
Confirm with .
OK:Program
0:Erase ¤:Info
Press to program the transmitter.
Button
Press the button of the transmitter.
XXXX accepted
If the transmitter is not accepted, see Section 6 Troubleshooting and error messages,
page 46.
Depending on the choice that you have made for the display mode, enter the value for the
floor, the room and the bed, or for a single 3-digit number, or for a 4-sign display. See
Section 4.2.4 Display mode, page 24.
The following example is for a 4-sign number display:
Enter the pager group value:
Confirm the value with
Stored !
and
£
. Press to erase and go back. Confirm with
.
User Manual
NurseCall Main Unit
then .
.
Bosch Security Systems
.