Selecting Finishing Modes; Finishing Modes And Finishers (Optional) - Oce im2330 / im2830 Operator's Manual

3. SELECTING FINISHING MODES

Finishing Modes and Finishers (Optional)

The functions available differ depending on whether a finisher is installed and which type of finisher (9284,
9256, IM2300030 and IM2300040) it is.
* The touch panel used in this chapter appears when the optional saddle-stitch finisher (optional) with hole
punch unit (optional) is installed in your copier.
3
Type of Finishing Mode
- 9256: Saddle-stitch finisher
- 9284: Single-staple finisher
- IM2300030: Job separator
- IM2300040: Offset tray
- IM2300020: Hole punch unit
Confirm the finishing mode type of your equipment with the following table.
Finishing
9256 + IM2300020
9256
9284
IM2300030
IM2300040
No finisher
Names of each Finisher (Optional)
1: Trays
2: Sub-trays
3: Upper cover
4: Hole punch unit
5: Front cover
84
3.SETTING OF BASIC COPY MODES
Type of finishing mode
Sort/ Rotate Staple
Group sort sort
Y Y Y
Y Y Y
Y Y Y
Y Y N
Y Y N
Y Y N
Magazine Magazine sort
sort + Saddle stitch
Y Y
Y Y
Y N
Y N
Y N
Y N
Y: Available
N: Not available
Saddle Hole
stitch punch
Y Y
Y N
N N
N N
N N
N N