GENERAL PRECAUTIONS
When Installing or Moving
Warning
- This multifunctional digital systems requires 115 V AC, 12 A 50/60 Hz electric power.
DO NOT use a power supply with a voltage other than that specified.
Avoid multiple connections in the same outlet. This could cause a fire or give you an electric shock. If you
are considering increasing the number of outlets, contact an electrician.
- ALWAYS connect this multifunctional digital systems to an outlet with a ground connection to avoid the
danger of fire or electric shock in case of short-circuiting. Contact your service representative for the
details. Be sure to use a 3-conductor, grounded wall outlet.
In areas, except U.S. and Canada, where a 2-pin plug is used, the multifunctional digital systems must
be grounded for safety. Never ground it to a gas pipe, a water pipe, or any other object not suitable for
grounding.
- Plug the power cord securely into the outlet. If it is not plugged in properly, it could heat up and cause a
fire or give you an electric shock.
- DO NOT damage, break or attempt to repair the power cord.
The following things should not be done to the power cord.
- Twisting it
- Placing anything on it
This could cause a fire or give you an electric shock. If the power cord is damaged, contact your service
representative.
- When removing the plug from the outlet, DO NOT PULL the power cord. ALWAYS hold the plug when
removing it from the outlet. If the power cord is pulled, the wires may become broken and this could cause
a fire or give you an electric shock.
- Make sure that the ventilation holes are not blocked up.
If the temperature within the multifunctional digital systems becomes too high, a fire could result.
- DO NOT move the multifunctional digital systems to another building, up and down the stairs or for any
great distance.
This could cause an injury or give you and electric shock. When lifting or moving the multifunctional digital
systems, contact your service representative.
- DO NOT move the multifunctional digital systems with optional equipment, such as the finisher, attached.
This could cause a fire or give you an electric shock. When lifting or moving the multifunctional digital
systems, contact your service representative.
- When moving the multifunctional digital systems, be sure to shut down the power prior to pulling out the
plug from the outlet. If the power cord is damaged, this could cause a fire or give you an electric shock.
- The socket outlet should be near the equipment and be easily accessible.
- Pull out the plug from the outlet more than once a year to clean around the prongs. Accumulating dust
and dirt could cause a fire due to the heat released by electric leakage.
- Bending it
- Pulling it
- Making it hot
- Situating it near radiators or other heat sources
11