Oce im2330 / im2830 Operator's Manual page 138

13.JOB BUILD (Cont.)
8
On the Basic screen, set the settings for
the 2nd job.
- The settings for the 2nd job or later can be changed with regard
to the following functions.
Reproduction ratio, automatic magnification selection, original
size, other size
Scanning mode
Image adjustment mode
Edge erase, dual-page
- When the 1st job is set and 2-sided copying (or 1-sided copying)
is selected, the setting cannot be changed to 1-sided copying (or
2-sided copying) from the 2nd job.
5
- Press the [SETTING] button to confirm the settings.
- To change the settings, press the [FC] button, and then start the
procedure again from step 1.
- Be aware that copying will be performed in the same modes as
those of the 1st job if the copy modes are not changed.
9
After having completed the settings,
press the [START] button.
- Scanning the originals starts.
- For the 3rd job or later, repeat from step 6 to 9.
- Any number of jobs can be set until the total number of scanned
original pages reaches 1000.
10
After having completed all the settings
and scanning of the originals, press the
[JOB FINISH] button on the Basic screen.
- When copy and e-file/file function are set, storing starts.
134
5.USING THE EDITING FUNCTIONS