Drive Belt Replacement - Troy-Bilt Bronco CRT Service Manual

4.

DRIVE BELT REPLACEMENT:

4.1. Remove the spark plug boot from the spark plug
and ground it to the engine. See Figure 4.1.
Spark
Plug
Figure 4.1
4.2. Remove the hex flange screw and large flat
washer securing the belt cover to the lower
cable mounting bracket using a 3/8" socket. See
Figure 4.2.
Hex Flange Screw
Large Flat Washer
Belt Cover
Clutch Cable
Figure 4.2
4.3. Pivot the belt cover on the forward clutch cable
until it is out of the work area.
Spark Plug Boot
Grounded
Troy-Bilt Small Frame Tillers
4.4. Remove the belt from the engine drive pulley
and forward idler pulley. See Figure 4.4.
Drive Pulley
Forward Idler Pulley
4.5. Remove the belt from the transmission pulley.
See Figure 4.5.
Transmission
Pulley
4.6. Install the new belt in the reverse order above.
NOTE: Make certain the belt keepers are cor-
rectly positioned prior to installing the belt cover.
4.7. Perform the Forward Clutch Cable Adjustment
section.
5
Drive Belt
Figure 4.4
Belt
Figure 4.5