Troy-Bilt Bronco CRT Service Manual page 12

Troy-Bilt Small Frame Tillers
6.12. Remove the depth regulator assembly and drag
bar assembly. See Figure 6.12.
Depth Regulator Assembly
Hood Brackets
Drag Bar
Figure 6.12
NOTE: There is a cut a way in the tine hood to
allow the depth bar's spiral pin to pass through.
See Image Below.
Cut A Way for Spiral Pin
6.13. Lower the unit back onto the tines.
NOTE: Make certain the unit is resting on the
tines and not on the trailing shield.
Cut A Way
6.14. Raise the front of the tiller up until the wheel
assemblies are off the ground. See Figure 6.14.
Wheels off Ground
6.15. Remove both hair pins and clevis pins securing
the wheel assemblies onto the wheel shaft using
needle nose pliers. See Figure 6.15.
Hair Pin
6.16. Remove both wheel assemblies.
8
Raise the Unit Up
Figure 6.14
Clevis Pin
Figure 6.15