Troy-Bilt Bronco CRT Service Manual page 38

Troy-Bilt Small Frame Tillers
1.4. Cut the cable tie securing the reverse clutch
cable to the handlebar assembly using side cut-
ters. See Figure 1.4.
Reverse Clutch
Cable
Figure 1.4
NOTE: Make certain the reverse clutch cable is
cable tied during assembly.
1.5. Remove the hex flange screw and large flat
washer securing the belt cover to the belt cover
bracket using a 3/8" socket. See Figure 1.5.
Flat Washer
Hex Screw
Figure 1.5
1.6. Pivot the belt cover around the forward clutch
cable until it is out of the work area.
1.7.
Belt
Cover
Bracket
Cable Tie
Jam
Nut
1.8.
1.9.
Reverse
Clutch
Cable
Belt Cover
1.10. Leave the belt cover off at this time.
1.11. Perform the Reverse Clutch Cable Adjustment
34
Remove the inside jam nut securing the reverse
clutch cable to the belt cover bracket using two
1/2" wrenches. See Figure 1.7.
Inside Jam Nut
Reverse Clutch Cable
Figure 1.7
Remove the reverse clutch cable's Z-fitting from
the reverse idler arm.
NOTE: The reverse return spring will drop off its
anchoring position at the left frame rail. Make
certain it is correctly installed during assembly.
Install a new reverse clutch cable in the reverse
order above. See Figure 1.9.
Figure 1.9
section.