Troy-Bilt Bronco CRT Service Manual page 14

Troy-Bilt Small Frame Tillers
6.24. Pivot the upper handlebar assembly up until the
pulley/belt guard is flat on the floor. See Figure
6.24.
Pivoted Forward
Pulley/Belt Guard
Figure 6.24
6.25. Secure the upper handlebar in position from
above.
6.26. Remove the transmission assembly from
between the engine brackets and front assem-
bly. See Figure 6.26.
Transmission Assembly
Figure 6.26
NOTE: A small pry bar can be used for assis-
tance, if necessary.
6.27. Set the unit on a bench.
Engine Brackets
10
6.28. Remove the forward return spring from the for-
ward idler lever. See Figure 6.28.
Figure 6.28
NOTE: There are two holes at the bottom of the
forward idler lever. The right lower hole (in the
operators position) is used for the Tuffy tiller.
6.29. Remove the hex screw and belleville washer
securing the transmission pulley to the drive
shaft assembly using a 1/2" socket. See Figure
6.29.
Hex Screw
Belleville Washer
Figure 6.29
Forward
Idle Lever
Two Holes
Forward Return Spring
Transmission
Pulley