Troy-Bilt Bronco CRT Service Manual page 13

6.17. Remove the forward return spring from the right
engine bracket using needle nose pliers. See
Figure 6.17.
Idler Lever
Figure 6.17
6.18. Pivot the forward idler lever inward.
6.19. Secure the upper handlebar in position from
above. See Figure 6.19.
Upper Handlebar Secured
Figure 6.19
NOTE: The unit needs to be stabilized before
removing the transmission.
6.20. Remove both sets of hex screws securing the
Right
Engine
Bracket
Transmission
Return Spring
6.21. Remove both self-tapping hex screws securing
6.22. Grasp the front of the unit and raise it up until the
6.23. Lower the front of the unit until the pulley/belt
9
Troy-Bilt Small Frame Tillers
left and right engine brackets to the transmission
using a 1/2" socket. See Figure 6.20.
Hex Screws
Figure 6.20
the lower forward cable mounting bracket to the
left engine bracket using a 3/8" socket. See Fig-
ure 6.21.
Cable Mounting Bracket
Figure 6.21
front support can be removed.
guard is setting on the ground.
Engine
Bracket
Self-Tapping
Screws
Engine Bracket