Troy-Bilt Bronco CRT Service Manual page 17

7.6. Allow all of the gear oil to drain from the trans-
mission case assembly.
7.7. Rotate the transmission 180° to the right until it
is in the upright position.
7.8. Remove the front transmission cover gasket
from the transmission using a scraper. See Fig-
ure 7.8.
Wheel Worm
Figure 7.8
7.9. Remove all four hex flange screws securing the
rear transmission cover and gasket to the trans-
mission housing assembly using a 1/2" socket.
See Figure 7.9.
Hex Screws
Rear Transmission Cover
Figure 7.9
7.10. Remove the rear transmission cover gasket from
Cover Gasket
7.11. Remove the remaining lower hex flange screw
Rear Bearing Cap
Short Hex Flange Screw
7.12. Break the rear bearing cap free from the trans-
13
Troy-Bilt Small Frame Tillers
the transmission using a scraper. See Figure
7.10.
Cover Gasket
Figure 7.10
securing the rear bearing cap to the transmis-
sion housing assembly using a 1/2" socket. See
Figure 7.11.
Figure 7.11
mission housing at any overlap position using a
punch and hammer.
Tine Worm
Transmission
Overlap Point