Table of Contents
Advertisement
Advertisement
Table of Contents
Related Manuals for Troy-Bilt TB25GHT
Summary of Contents for Troy-Bilt TB25GHT
- Page 1 Operator’s Manual 2-Cycle GAS HEDGE TRIMMER Model TB25GHT • SAFETY CAUTION: Before using this product, • ASSEMBLY read this manual and follow all safety • OPERATION rules and operating instructions. • MAINTENANCE • PARTS LIST P/N 9096-MD2001 PRINTED IN TAIWAN...
-
Page 2: Table Of Contents
TABLE OF CONTENTS Warranty Page Maintenance Pages 12 - 15 Safety Rules Pages 3 - 7 Troubleshooting Page Oil and Fuel information Page Specifications Page Starting / Stopping instrustion Pages 9 - 10 Parts List Page Trimmer Instructions Page WARRANTY STATEMENT TWO YEAR LIMITED WARRANTY ON TROY BILT HEDGE TRIMMER For two years from the date of purchase, when this Hedge trimmer is used and maintained according to the operator’s manual, Troy Bilt will repair any defect in material or workmanship free of charge. -
Page 3: Safety Rules Pages
RULES FOR SAFE OPERATION SYMBOL MEANING The purpose of safety symbols is to attract your atten- tion to possible dangers. The safety symbols, and their explanations, deserve your careful attention and under- DANGER: standing. The safety warnings do not by themselves Failure to obey a safety eliminate any danger. -
Page 4: Rules For Safe Operation
RULES FOR SAFE OPERATION WHAT TO DO WHAT NOT TO DO READ YOUR USER MANUAL AND ALL SUPPLEMENTS DO NOT USE ANY OTHER FUEL than that recom- (IF ANY ENCLOSED) THOROUGHLY BEFORE OPERAT- mended in your manual. Always follow instructions in ING YOUR UNIT. -
Page 5: Save These Instructions
RULES FOR SAFE OPERATION SPECIAL NOTE: Exposure to vibrations through pro- HEDGE TRIMMER SAFETY RULES longed use of gasoline powered hand tools could cause The Hedge Trimmer must not be used by anyone blood vessel or nerve damage in the fingers, hands, and under the age of 16. - Page 6 RULES FOR SAFE OPERATION SAFETY AND INTERNATIONAL SYMBOLS This operator's manual describes safety and international symbols and pictographs that may appear on this product. Read the operator's manual for complete safety, assembly, operating and maintenance and repair information. SYMBOL MEANING SYMBOL MEANING •...
- Page 7 RULES FOR SAFE OPERATION KNOW YOUR HEDGE TRIMMER HEDGE TRIMMER COMPONENTS 11. Starter Handle 12. Safety Switch Blades 13. Rear Handle Safety Guard 14. Throttle Trigger Front Handle 15. Muffler Cover Primer Bulb Fuel Cap ON-OFF Switch Throttle Lock Choke Lever Air Filter Cover 10.
-
Page 8: Oil And Fuel Information
OIL AND FUEL INFORMATION OIL AND FUEL MIXING INSTRUCTIONS To Obtain Correct Fuel Mix: Old and/or improperly mixed fuel are the main reasons Thoroughly mix the proper ratio of 2-cycle engine oil with for the unit not running properly. Be sure to use fresh, unleaded gasoline in a separate fuel can. -
Page 9: Starting / Stopping Instrustion Pages
STARTING/STOPPING INSTRUCTIONS STARTING A COLD ENGINE (Above 55˚F) Mix the bottle of 2-cycle oil (included) with 1 gallon of unleaded gasoline (less than 30 days old). Combine them in a separate container using a 40:1 ratio. Pour into fuel tank. 1. -
Page 10: Stopping The Engine
STARTING/STOPPING INSTRUCTIONS WARM ENGINE START Normal Stopping Method. For normal stopping, release 1. Move ignition switch to the “RUN (I)” position. trigger and allow engine to return to idle speed. Then 2. Place choke in PARTIAL CHOKE “ ” position (Figure DEPRESS the OFF “STOP ”... -
Page 11: Trimmer Instructions
TRIMMING INSTRUCTIONS ADDITIONAL SAFETY PRECAUTIONS Before operating your unit, review ALL SAFETY PRECAU- TIONS in this manual. WARNING / CAUTION • IF UNFAMILIAR WITH TRIMMING techniques, prac- tice the procedures with ENGINE in “OFF” position. • ALWAYS CLEAR WORK area of debris such as cans, bottles, rocks, etc. -
Page 12: Maintenance Pages
MAINTENANCE AND REPAIR INSTRUCTIONS MAINTENANCE SCHEDULE WARNING: To prevent serious Perform these required maintenance procedures at the fre- injury, never perform quency stated in the table. These procedures should also maintenance or repairs with unit running. be a part of any seasonal tune-up. Always service and repair a cool unit. -
Page 13: Maintenance And Repair Instructions
MAINTENANCE AND REPAIR INSTRUCTIONS AIR FILTER CLEANING TRIMMER BLADES Trimmer blades should be cleaned periodically to remove CAUTION: sap and accumulated debris. NEVER operate hedge trimmer with- To Clean Blades: out the air filter. The air filter must be kept 1. - Page 14 MAINTENANCE AND REPAIR INSTRUCTIONS FUEL CAP / FUEL FILTER IDLE ADJUSTMENT The carburetor was pre-set at the factory for optimum CAUTION: Remove fuel from unit performance. If further adjustments are necessary take and store in approved your hedge trimmer to a Troy Bilt or other qualified serv- container before starting this procedure.
-
Page 15: Maintenance
MAINTENANCE AND REPAIR INSTRUCTIONS STORING A UNIT Failure to follow these steps may cause varnish to form in the carburetor and difficult starting or permanent damage following storage. 1. Perform all the general maintenance recommended in the Maintenance Section of your User Manual. 2. -
Page 16: Troubleshooting
TROUBLESHOOTING UNIT WON’T START OR STARTS BUT WILL NOT RUN C A U S E A C T I O N 1. Incorrect starting procedures 1. Follow instructions in the Starting/Stopping section 2. Incorrect carburetor mixture adjustment setting 2. Have carburetor adjusted by a Troy Bilt or other qualified service dealer 3. -
Page 17: Specifications
SPECIFICATIONS Engine Type ..............................Air-Cooled, 2-Cycle Displacement..................................25cc Speed ..............................3000±150 strokes/RPM Ignition Type ................................. Electronic Ignition Switch ..............................Rocker Switch Spark Plug Gap............................0.025 in. (0.635 mm) Lubrication ................................Fuel/Oil Mixture Fuel/Oil Ratio..................................40:1 Carburetor .................................. with primer Starter ............................Spring Assist Starting system Muffler ................................ -
Page 18: Parts List
PARTS LIST... - Page 19 EPA Emission Control Warranty Statement California / Your Warranty Rights and Obligations The California Air Resources Board, The Environmental Protection Agency and Troy Bilt are pleased to explain the emission control system warranty on your 2005 and later small off-road engine. In California and the 49 states, new small off-road engines must be designed, built and equipped to meet stringent anti-smog standards.
- Page 20 MANUFACTURER’S LIMITED WARRANTY FOR: No implied warranty, including any implied warranty of The limited warranty set forth below is given by Troy-Bilt merchantability or fitness for a particular purpose, LLC with respect to new merchandise purc hased and applies after the applicable period of express written used in the United States, its possessions and territories.
- Page 22 STOP For problems or questions, DO NOT ALTO return this product to the store. Contact your Customer Service Agent . Para problemas o preguntas, NO devolver este producto a la tienda Contacte a su Agente de Servicio al Cliente. U.S.A. Imported by: For Consumer Assistance Please Call MTD LLC P.O.