Transmission Removal - Troy-Bilt Bronco CRT Service Manual

6.

TRANSMISSION REMOVAL:

NOTE: Perform the Drive Belt Replacement sec-
tion through forward drive belt removal, prior to
performing this section. See Image Below
Remove Drive Belt
6.1. Loosen the hex nut securing the forward clutch
cable to the lower cable mounting bracket using
a 3/8" wrench and a 7/16" wrench.
6.2. Slide the forward clutch cable out of the lower
cable mounting bracket.
6.3. Pivot the forward clutch cable's Z fitting rear-
ward, and remove it from the forward idler lever.
6.4. Remove the lower portion of the forward clutch
cable from the belt cover.
6.5. Set the belt cover aside.
6.6. Remove both self tapping hex flange screws
securing the tine hood to the right and left hood
brackets using a 3/8" socket. See Figure 6.6.
Self Tapping
Hex Flange Screws
Figure 6.6
6.7. Grasp the upper handlebar and pivot the unit
onto it's nose.
6.8. Secure the handlebar from above.
6.9. Pivot the trailing shield up.
6.10. Remove the hex screw, bushing, lock washer
and lock nut securing the drag bar to the bottom
of the transmission using a 1/2" socket and
Remove
wrench. See Figure 6.10.
Drive Belt
6.11. Remove both hex flange screws securing the
hood brackets to the transmission assembly
using a 1/2" socket. See Figure 6.11.
Hex Flange Screws
7
Troy-Bilt Small Frame Tillers
Lock Washer
Lock Nut
Figure 6.10
Hood
Brackets
Figure 6.11
Hex Screw