Troy-Bilt Bronco CRT Service Manual page 26

Troy-Bilt Small Frame Tillers
8.5. Locate two sets of miscellaneous flat washers
that would equal approximately.120" in thick-
ness. See Figure 8.5.
Hex Flange Screws
Miscellaneous Washers
+/- .120" in Thickness
Per Side
Short Hex Screw and Lock Washer
Figure 8.5
NOTE: Measure the thickness of both washers
using a dial caliper. See Image Below.
Washers
Miscellaneous Flat Washer Thicknesses
Rear Bearing Cap
Dial Caliper
22
8.6. Install the front snap ring using snap ring pliers.
See Figure 8.6.
Front Snap Ring
Figure 8.6
8.7. Lubricate and install the front tapered roller bear-
ing race into the front of the transmission hous-
ing and up against the front retaining ring.
NOTE: The front race is installed from inside the
transmission housing.
8.8. Carefully begin sliding the drive shaft assembly
into the transmission housing until it reaches the
drive shaft area. See Figure 8.8.
Tapered Roller Bearing
Figure 8.8
8.9. Slide the support washer and front tapered roller
bearing onto the drive shaft assembly.
8.10. Slide the drive shaft assembly into the front
tapered roller bearing race.
Race
Slide Drive Shaft Assembly
Into Position
Support Washer