Programming Menu - Ultra Start 1155 Series Install Manual

Programming Menu

Turn the ignition key to the on position 3 times then press and release the program
button. The park lights will turn on and the horn(Optional) will honk once. While the
park lights are on press and release the program button until the LED is flashing the
same number of times as the program setting that is to be changed. Press and hold
the program switch until the park lights flash the correct number of times as the
option to be programmed.
Setting 1- Start Trigger Input- Number of pulses to activate Remote Starter
1 Three Pulses
2 Two Pulses
3 One Pulses
Press the Program Button 1 time to select setting 1 (This will be confirmed by 1 LED flash)
Press and hold the Program Button until you receive the appropriate # of park light flashes and/or horn honks.
Release the Program Button momentarily to move to next program step or repeat to change selection
Setting 2- Special Door Lock/ Unlock Operations
1 Type 1
2 Type 2
3* Normal Operation 3 Flashes
Press the Program Button 2 times to select setting 2 (This will be confirmed by 2 LED flashes)
Press and hold the Program Button until you receive the appropriate # of park light flashes and/or horn honks.
Release the Program Button momentarily to move to next program step or repeat to change selection
Setting 3- Gas/ Diesel Mode- Blue Wire on 14-Pin
1 (-) Glow Plug
.
2 15 Seconds Delay
3* Gas/ + Glow Plug
Press the Program Button 3 times to select setting 3 (This will be confirmed by 3 LED flashes)
Press and hold the Program Button until you receive the appropriate # of park light flashes and/or horn honks.
Release the Program Button momentarily to move to next program step or repeat to change selection
Setting 4- Rearm Output- Yellow Wire on 14-Pin
1 Type 1
2 Type 2
3* Factory Re-arm
Press the Program Button 4 times to select setting 4 (This will be confirmed by 4 LED flashes)
Press and hold the Program Button until you receive the appropriate # of park light flashes and/or horn honks.
Release the Program Button momentarily to move to next program step or repeat to change selection
1 Flash Three pulses required to activate the remote starter.
2 Flashes Two pulses required to activate the remote starter.
3 Flashes One pulse required to activate the remote starter.
1 Flash Unlock before start. Lock pulse after start and shutdown
2 Flashes Lock pulse only after remote starter shuts off
No additional re-lock pulses
1 Flash Waits a maximum 30 seconds before starting.
2 Flashes Ignition ON for 15 seconds before remote starting
3 Flashes Waits 2 seconds to start if no diesel input is detected
1 Flash Pulse after start and with lock
2 Flashes Pulse after start only
3 Flashes 0.75 second pulse with lock and after shutdown
Continued on next page...
.