Wiring Connections; Jumper Selections; Pin Connector - Ultra Start 1155 Series Install Manual

WIRING CONNECTIONS

6 Pin Power Connector
Yellow Starter
Green Heater
Red 12 power
Red 12 power
Blue Ignition 1
White Select Output

14 Pin Connector

Yellow Re-Arm
Red/White N/A
Brown Disarm
Orange (-) Output
White/Blue Horn
Black/White N/A
Purple (+) Start
White Park Lights
Green/White Hood Pin
Green (-) Start
Black Ground
Pink Brake
Blue/White Tach
Blue Glow Plug
* Connect only one start input. The start input will require 3 negative pulses within 2
seconds to activate the remote starter.
Note: 500ma outputs are low current and are designed to activate relays.
4 Pin Connector Blue - Program LED/ Switch
Program LED/Switch connector. The program switch is integrated into the LED. Press the
LED to activate the switch.

Jumper Selections

Position One
Position Two
*Position Three
* The Default Setting For The System Is Second Ignition Output.
The jumpers control the output from the white wire at the 6-pin harness. Place the jumper in the following
positions to change the output.
Note: The default jumper setting is second ignition.
Output on White wire
Second Starter
Second Accessory
Second Ignition
30amp output
30amp output
30amp input
30amp input
30amp output
30amp output
0.75sec Pulse On Shutdown. (500ma Output)
Not Used on this model.
0.75sec Pulse With Unlock And Before Start.(500ma Output)
(-) While Running
(-) Horn Honk Output
Not Used on this model.
Connect to positive start input.
Positive Park light Output - 10 Amp Max.
Negative Hood Pin Input - MUST BE CONNECTED!!
Connect to negative start input.
System Ground Input - MUST BE CONNECTED!!
Positive Brake Input - MUST BE CONNECTED!!
Tach Signal Input - Must be connected for Tach Mode!!
Programmable Input - DIESEL ONLY.
Second Starter
Second Accessory
Second Ignition
Jumper position
Position 1
Position 2
Position 3
12volts during crank only.
12volts in accessory off during start.
Constant 12volt power at ignition harness.
Constant 12volt power at ignition harness.
12volts in ignition and start positions.
Selectable Output. See jumper diagram.
Output On the White Wire From The 6-Pin Connector.
Output On The White Wire From The 6-Pin Connector.
Output On The White Wire From The 6-Pin Connector.