Table of Contents
Advertisement
TRANSMITTER PROGRAMMING
Use the following steps to program new remote to the system
STEP 1 - Open the hood.
STEP 2 - Turn ignition key ON-OFF-ON-OFF-ON Leaving Key ON.
STEP 3 - Hold brake down until lights flash and LED's come on solid.
About 5 seconds.
STEP 4 - Press the lock button on each transmitter to be programmed.
The park lights will flash 1 time each time a transmitter is learned.
NOTE : All transmitters to be used must be programmed at the same time
. Any transmitter not programmed in the same sequence will be erased from
the systems memory.
PRO SERIES 4-BUTTON TRANSMITTER
# 3 Start
RESET TO FACTORY DEFAULT
The following steps will reset any and all programmed features to Factory Default Settings.
ret
STEP 1 - Enter into Program Mode.
STEP 2 - On the transmitter press and release button #3 then #2 and #1.
The system will respond with three light flashes and three siren/horn (optional) chirps.
This confirms that the system and all it's programmable features and setting have been
reset to the Factory Default Settings.
# 1 Lock
TO ENTER PROGRAM MODE
STEP 1- Open the hood
STEP 2- Turn the ignition key ON/OFF, ON/OFF, ON
Leave the Ignition in the on position.
STEP 3- Press and release the button on the antenna once
The system will respond with one light flash and one (optional)
siren/horn chip to confirm the unit is in Program Mode.
# 2 Unlock
# 4 Car Finder
Advertisement
Table of Contents
