Tach Modes - Ultra Start 1172 Series Installation Manual

1172 SERIES
INSTALL MANUAL
TACH / TACHLESS & HYBRID MODES
SETTING 1
HYBRID VEHICLE 1
SETTING 2
HYBRID VEHICLE 2
SETTING 3
AUTO TACH/
TACHLESS
LEARNING
(DEFAULT)
***SEE PAGE 8 FOR TACH PROGRAMMING INSTRUCTIONS
Connect the Tach wire to a Fuel Injector, Coil Pack, Coil or
Crank Position Sensor. The system will Tach Learn the
first time the car is started. The start wire is the trigger for
the system to learn. (See Tach Learning)
Once the system has remote started the Tach input will
not be monitored for the programmed runtime.
Tach wire connection is not necessary. When the remote
starter is activated the system will power up normally with
the exception of the start output. The start output will stay
on for a preset time of 2 seconds then shut off.
This setting must be programmed before the system can
be remote started.
For Tach Mode connect the Tach wire to a Fuel Injector,
Coil Pack, Coil or Crank Position Sensor. The system will
Tach Learn the first time the car is started. The start wire
is the trigger for the system to learn. If the vehicle does
not have a start wire use the Manual Tach Learn
proceeder. (See Tach Learning)
In Tachless Mode the same procedure is followed except
a connection to a Tach source is not required.
SYSTEM PROGRAMMING - Menu 1
PROGRAM MODE
PAGE 22