Tach Learning - Ultra Start 1250 SERIES Install Manual

Installation Guide
Step 1 - Connect All Of the Following Wires
6 Pin Power Connector
Yellow Starter Output
Green Heater Output
Red 12 power Input
Red 12 power Input
Blue Ignition 1 Output
White Selectable Output
14 Pin Power Connector
Black System Ground
Pink Brake Switch
White Park Lights
Green/White Hood Pin
Blue/White Tach Wire
Manual Transmissions Only
Purple (+) Door Pin
Green (-) Door Pin
Black/White Park Brake
Note: Manual Transmission units MUST be set into Reservation Mode to remote start.
See page 12 for details.
Step 3- Auto Tach/ Tachless Learning (TL Models)

TACH LEARNING

1) Make all the required wire connections and plug-in the Unit.
**The park lights should flash twice upon power up.
2) Turn the Ignition Key ON. (The Park Lights will turn on).
3) Start the vehicle with the key, the LED's on antenna will come when proper tach signal is
detected. After 30 seconds the park lights will turn off then flash twice to confirm Tach learning.
* The system will flash the park lights seven times if not Tach/ Tachless learned and the start
button is pressed. The system must be Tach/ Tachless learned before remote starting.
** If the LED's do not come on during tach learn, a proper Tach signal was not detected.
Note: If the park lights do not flash in Auto Tach Learn Mode it may be necessary to
connect to a different tach source. For best results connect the tach to the coil pack or to a
fuel injector wire.
TACHLESS LEARNING (TL Models Only)
1) Make all the required wire connections and plug-in the Unit.
**The park lights should flash twice upon power up.
2) Turn the Ignition Key ON. (The Park Lights will turn on).
3) Start the vehicle with the key, the LED's on antenna will turn on after 30 seconds then the park
lights will turn off and flash twice to confirm Tachless learning.
Note: If the first ignition wire is connected to a wire that does not stay 12 volts in the start
position the system will not Tach/ Tachless learn.
Your Basic Install Is Complete!
NOTES:
Your Basic Installation is Now Complete!!
1) If the unit does not start, check the starter is not in Tach Lock Out or in Program Mode.
2) If the vehicle still does not start, check all connections and check for factory security.
Connect To The Vehicles Starter Wire.
Connect To The Vehicles Accessory Wire.
Connect To Constant 12 Volt Power Source- High Current.
Connect To Constant 12 Volt Power Source- High Current.
Connect To The Vehicles Primary Ignition.
Default Second Ignition Output. See Page 5.
Connect To Chassis Ground.
Connect To (+) When Brakes Applied.
Connect To (+) Park Light System.
Connect To Hood Pin Switch.
Connect To A/C Tach Source. Tach Models Only
Connect to door pin on vehicles with (+) door pin systems.
Connect to door pin on vehicles with (-) door pin systems.
Connect to Park brake switch. (-) when switch is applied.
Page 6