Ultra Start 1172 Series Installation Manual page 23

PAGE 23
TRANSMITTER PROGRAMMING
SYSTEM PROGRAMMING - Menu 1
The system can lean up to 4 different remote's. Each remote to be used MUST be
programmed together during the same sequence. For security, when a new remote is
programmed all previous remote's are deleted. Please see remote operation chart for
information on using Second Car / Pad Lock Operations.
ENTERING REMOTE PROGRAM MODE
Cycle the Ignition Key - ON/OFF ON/OFF ON (Leaving the key ON)
1 -
HOLD program switch, the HORN will Honk ONCE and the park lights will turn on.
2 -
(If the HORN does not Honk repeat step 1)
CONTINUE TO HOLD until HORN Honks 5 times
3 -
PROGRAMMING REMOTE'S
4 -
Press & Release the START button on each of the remote transmitters
to be programmed.
HORN will Honk 1 time to confirm each remote has been
5 -
programmed (If the HORN does not Honk press button again)
Turn ignition key OFF to exit remote program mode when
6 -
all required remote's have been programmed.
1 Honk confirms program mode entered followed by 5 Honks confirming
transmitter program mode
1172 SERIES
SYSTEM PROGRAMMING - Menu 1
INSTALL MANUAL