Weider 900 User Manual page 12

18. Apply grease to an M10 x 78mm Bolt (54).
Attach a Pulley Arm (38) to the Upright (3) with
the Bolt and an M10 Nylon Locknut (68). Do
not overtighten the Nylon Locknut; the
Pulley Arm must pivot easily.
Route the Press Cable (49) over a 90mm Pulley
(34). Attach the Pulley, a Cable Trap (36), an
M10 Washer (70), and two Finger Guards (35)
to the indicated side of the Pulley Arm (38) with
an M10 x 52mm Bolt (52) and an M10 Nylon
Locknut (68). Make sure that the Cable Trap
is oriented to hold the Cable in the groove
of the Pulley.
19. Slide the end of the Press Cable (49) onto the
hook on the Right Arm (6).
20. Identify the Short Cable (47). Attach the eye-
let on the Cable to the Base (1) with an M10 x
70mm Bolt (57), an M10 Washer (70), and an
M10 Nylon Locknut (68). Do not overtighten
the Nylon Locknut.
18
52
38
35
36
34
70
35
68
19
49
6
20
68
12
Grease
54
68
49
3
70
57
1
47