Weider 900 User Manual page 15

SEAT ASSEMBLY
28. Attach the Backrest (18) to the Upright (3) with
two M6 x 63mm Screws (67) and two M6
Washers (73).
29. Orient the Seat (19) as shown, and attach it to
the Seat Frame (8) with four M6 x 16mm
Screws (40).
30. Make sure that all parts have been properly tightened. The use of all remaining parts will be explained in
ADJUSTMENTS, beginning on the next page. Before using the weight system, pull each cable a few times to
make sure that the cables move smoothly over the pulleys. If one of the cables does not move smoothly, find
and correct the problem. IMPORTANT: If the cables are not properly routed, they may be damaged when
heavy weight is used. See the CABLE DIAGRAM on page 18 for proper cable routing. If there is any
slack in the cables, you will need to remove it by tightening the cables; see TROUBLESHOOTING AND
MAINTENANCE on page 19.
28
18
Wide End
29
19
Wide
End
8
15
67
73
3
67
73
40
40