Schwinn 450 Elliptical Assembly Manual page 50

Condition/Problem
No speed/RPM reading,
Console displays "Please
Stride" error code
Console shuts off (enters
sleep mode) while in use
50
Things to Check
Check data cable integrity
Check data cable
connections/orientation
Check magnet position
(requires shroud removal)
Check Speed Sensor (re-
quires shroud removal)
Check electrical (wall)
outlet
Check connection at front
of unit
Check data cable integrity
Check data cable
connections/orientation
Reset machine
Check magnet position
(requires shroud removal)
Check Speed Sensor
Solution
All wires in cable should be intact. If any
are cut or crimped, replace cable.
Be sure cable is connected securely
and oriented properly. Small latch on
connector should line up and snap into
place.
Magnet should be in place on pulley.
Speed sensor should be aligned with
magnet and connected to data cable.
Realign sensor if necessary. Replace if
there is any damage to the sensor or
the connecting wire.
Make sure unit is plugged into a func-
tioning wall outlet.
Connection should be secure and un-
damaged. Replace adapter or connec-
tion at unit if either are damaged.
All wires in the cable should be intact. If
any are cut or crimped, replace cable.
Be sure cable is connected securely
and oriented properly. Small latch on
connector should line up and snap into
place.
Unplug unit from electrical outlet for 3
minutes. Reconnect to outlet.
Magnet should be in place on pulley.
Contact Customer Care for further
assistance.