Table of Contents
Advertisement
The following table describes the parameters of this page:
Field
Rule Index
Rule Type
Local Start/End
IP
Public Start/End
IP
5.5.4.
QoS
The QoS provides better service of selected network traffic over various
technologies. This function can be set based on the physical LAN ports or
wireless interfaces under IPv4 or IPv6 version respectively.
IP Version: IPv4
Choose Advanced Setup > QoS, the page shown in the following figure
appears.
The Virtual server rule index for this VC. You can specify
10 rules in maximum. All the VCs with single IP will use
the same Virtual Server rules.
Choose the One-to-One, Many-to-One, Many-to-Many
Overload, Many-to-Many No Overload, or Server.
Enter the local IP Address you plan to map to. Local Start
IP is the starting local IP address and Local End IP is the
ending local IP address. If the rule is for all local IPs, then
the Start IP is 0.0.0.0 and the End IP is 255.255.255.255.
Enter the public IP Address you want to use for NAT.
Public Start IP is the starting public IP address and Public
End IP is the ending public IP address. If you have a
dynamic IP, enter 0.0.0.0 as the Public Start IP.
Description
69
Advertisement
Table of Contents
