Table of Contents
Advertisement
Field
Encapsulation
IP Unnumbered
Connection Setting
Connection
TCP MSS Option
IP Common Options
Default Route
IPv4 Address
Get IP Address
Static IP Address
IP Subnet Mask
Gateway
TCP MTU Option
NAT
Dynamic Route
Direction
Multicast
You can choose PPPoE LLC, PPPoE VC-Mux, PPPoA
LLC or PPPoA VC-Mux.
Select Activated or Deactivated.
You can choose Always On (Recommended),
Connect On-Demand or Connect Manually.
You can set a TCP MSS value. The range is from 100
to 1452. The default is 1400.
You can enable or disable default route.
You can choose Static or Dynamic.
You can enter the IP address for dial-up, which is
provided by your ISP.
The default is 255.255.255.255.
You can enter the gateway IP for dial-up, which is
provided by your ISP.
You can set a TCP MTU value. The range is from 100
to 1500. The default is 1492.
Select
whether
Translation (NAT) function. If you do not enable NAT,
you must add a route on the uplink equipment,
otherwise Internet access will fail. Normally NAT is
enabled.
You can select RIP1, RIP2-B or RIP2-M.
You can select None, Both, IN Only or OUT Only.
IGMP (Internet Group Multicast Protocol) is a
session-layer protocol used to establish membership
in a multicast group. The ADSL Router supports both
IGMP version 1 (IGMP v1) and IGMP version 2 (IGMP
55
Description
to
enable
Network
Address
Advertisement
Table of Contents
