Connect Gas Supply - Weber Summit Series Installation And Owner's Manual

CONNECT GAS SUPPLY

A 58 inch (147.32 cm) corrugated gas line is supplied with the grill. This line needs to
pass through the gas inlet opening to the main gas supply.
1) Connect the corrugated gas line to the manifold located on the right hand side of grill
under the control panel. Use the 1/2" flared gasket (1) to ensure proper seal.
Note: 1/2" flared gaskets are included in the Summit
included with your grill.
The corrugated line passes through the "Island Structure" cavity to the regulator
®
connection inside the Summit Built-In tank cabinet (#21280) or the hose and regulator
connection inside the tank enclosure. (Shown below)
2) Uncap one flare fitting from the 90º Connection located inside the Summit
Tank Enclosure.
3) Use the 1/2 (12.7 mm) inch flared gasket to ensure proper seal.
NOTE: Only use the 3/8 inch (9.53 mm) flared gasket if you are installing the optional
side burner.
4) Connect the corrugated gas line to the 90º Connection.
SIDE BURNER GAS SUPPLY CONNECTIONS
1
Corrugated Gas Line to Manifold
2
Plug unused hole with supplied plug
3
Use bushing for gas line hole
4
1/2" (12.7mm) Flared Gasket
5
6
Cap (Optional Side Burner)
a Top View
b Top of Box
c Back of Box
d Side View
WWW.WEBER.COM
®
®
Built-In tank cabinet (#21280) or
®
Built-In
S-440, S-640
90° Fitting
ASSEMBLY
a
2
c
(1)
b
1
5
3
4
6
d
7
7