Connect Gas Supply; Connection Chart - Weber Summit 43267 Installation Manual

ConnECt gaS SUPPLY

A 58 inch (147.32 cm) corrugated gas line is supplied with the grill. This line needs to
pass through the gas inlet opening to the main gas supply.
1) Connect the corrugated gas line to the manifold located on the right hand side of grill
under the control panel. Use the 1/2" flared gasket (1) to ensure proper seal.
Note: 1/2" flared gaskets are included in the Summit
included with your grill.
The corrugated line passes through the "Island Structure" cavity to the hose and
regulator connection inside the tank enclosure. (Shown in illustration)
2) Uncap one flare fitting from the 90º Connection on the regulator hose located inside
the tank enclosure.
3) Use the 1/2 (12.7 mm) inch flared gasket to ensure proper seal.
NOTE: Only use the 3/8 inch (9.53 mm) flared gasket if you are installing the optional
side burner.
4) Connect the corrugated gas line to the 90º Connection.

COnnECTiOn CharT

a Top View
b Typical tank cabinet or tank enclosure location
C Side View
d Top of Box
E Back of Box
i
Corrugated Gas Line to Manifold
ii 90° fitting
iv
1/2" (12.7 mm) Flared Gasket
v Cap (Optional Side Burner)
www.wEBEr.COM
®
Gas sUPPlY
®
Built-In tank Enclosure Kit
1
A
B
i
iv
E
v
C
31
31
D
ii