Section 5-Arms; Installing The Optional Swingaway Padded Armrest Socket Assembly - Invacare Crossfire T6 Owner's Operator And Maintenance Manual

SECTION 5—ARMS
After ANY adjustments, repair or service and BEFORE use, make sure all attaching
hardware is tightened securely - otherwise injury or damage may occur.
DO NOT attempt to lift or tilt a wheelchair by using any removable (detachable)
parts. Lifting by means of any removable (detachable) parts of a wheelchair may
result in injury to the user or damage to the wheelchair.
Installing the Optional Swingaway Padded Armrest
Socket Assembly
NOTE: For this procedure, refer to FIGURE 1.
1. Fold down the back. Refer to Unfolding/Folding the Back on page 30.
2. Install the arm socket on the arm socket plate using the two short mounting screws,
four washers and locknuts.
3. Remove the two existing mounting screws and locknut located on the back cane
mounting bracket. Discard the two existing mounting screws. Retain the locknut for
installing the swingaway padded armrest socket assembly.
NOTE: Position arm socket towards outside and rear of the wheelchair frame.
4. Align the mounting holes in the arm socket plate and wheelchair frame.
NOTE: When performing STEP 5, use the two mounting screws supplied with the kit.
1
5. Using the 2 / inch mounting screw and 1
2
locknut, secure the arm socket plate to the wheelchair frame in the orientation shown
in FIGURE 1 . Securely tighten.
6. Repeat STEPS 2‐5 for the opposite arm socket.
Part No 1134872
WARNING
1
/ inch mounting screw, coved washers and
4
27
Arms
™
Crossfire Series Wheelchairs