Adjusting Seat Position On Seat Frame; Asba Model; Van Seat Model - Invacare Pronto M94 Owner's Manual

SECTION 7—SEAT
Rear Adjustable
Height Tube
Mounting
Hole
A
B
C
D
E
Support
Tube

Adjusting Seat Position on Seat Frame

ASBA Model

DO NOT attempt to adjust the seat position of the ASBA seat on the seat frame.
This procedure MUST be performed by a qualified technician.

Van Seat Model

NOTE: For this procedure, refer to FIGURE 7.6 on page 53.
1. Remove the seat. Refer to Removing/Installing the Seat Assembly on page 50.
2. Remove the four mounting screws and washers securing the seat assembly to the seat
frame. (Detail "A" of FIGURE 7.6)
3. Separate the seat assembly from the seat frame.
4. Refer to Detail "B" of FIGURE 7.6 to determine the correct mounting holes to achieve
the desired seat position.
5. Align the seat assembly mounting holes determined in STEP 4 with the seat frame
mounting holes determined in STEP 4.
6. Using the four mounting screws and washers, secure the seat assembly to the seat
frame. Securely tighten.
7. Reinstall the seat. Refer to Removing/Installing the Seat Assembly on page 50.
Pronto® M94™
FIGURE 7.5 Adjusting the Seat Height
WARNING
52
Front
Adjustable
Height Tube
Locknut
Mounting
Mounting
Hole
A
B
C
D
E
Screws
Part No 1122145